Combined mixer

efore installation, check the tightening of the screws for securing the axle and the smooth running without jamming. The mixer is installed on the sealant to prevent air sucking. Do not forget to pry the side fitting. The location of the gas inlet is on the side of the gas reducer. During installation, it should be taken into account that the throttle valve opens at 90 degrees, and the “anti-clap” plate opens. If they “meet”, the engine control unit will take this as an error, and will put the system into emergency mode. (Before removing the terminal from the battery) To prevent the error, you must install an “anti-clap”, ensuring a strictly vertical movement of the “tab”, and not to the side!